Very slow wifi with new router
I recently changed my internet provider and switched from a Sagecom F@st 3890 router to a Hitron CGNV4. I use a Cisco Linksys wireless network adapter to connect to wifi on my elementary OS 5.1 system...
View ArticleRemote Server Configuration
I have a NAS Server on my network.Recently, there was a power cut in my area, and when the router came back up, the LAN IP of my server remained the same, but the remote IP of my server was changed....
View ArticleCannot connect to an external drive attached to my routers USB
I have been trying to connect to an external WD My Book connected via USB to my TP-Link Archer C9 router and formatted ex-FAT. I've been trying from a terminal on my Ubuntu 20.04 web-server. I always...
View ArticleGetting traced route list after sending packet from source to destination
So after I realized internet is just connection between routers and every routers have IP address, I want to know route of my already traversed packet.I mean, look this example case:Suppose my device A...
View ArticleIPforwarding for gateway not allowing certain software installs
I have a pi gateway I ultimately want to use as a VPN gateway but I'm having some issues with it being a normal gateway right now... Currently my set up is the following:Laptop > (eth1...
View ArticleProblem IPV6 DNSMASQ with only DHCP/DNS servers (OpenWRT)
I've set up DHCP ... and so far so good. The problem is when I try to connect a device. I did a test with Linux and each time it only sets me 1 DNS (i have set two dns server in DHCP server).It also...
View ArticleIs there any way to scan a lan network with dhcp enabled to see the IP of the...
I am running a local network over a home router with dhcp enabled. So in case of any reboot of the router, my devices get some random IP within a given range. Is there any way to check the IPs of the...
View ArticleLinux as a router to forward
How to make an OpenStack instance to forward route to another Linux machine which is not OpenStack instance but in the same LAN?PC_A has 192.168.1.133/27.PC_B has 192.168.1.140/27.PC_A has...
View ArticleConfused about OpenWrt's Firewall Zone Settings Definition
My router (which runs OpenWrt Attitude Adjustment 12.09) has a public IP address,and my computer is in my LAN. So naturally I'm going to masquerade outbound (me → Internet) trafficto make it possible...
View ArticleDoes DHCP on dd-wrt support the absence of the default route?
I have one reason to flash dd-wrt onto my router (rt-ac66u), which is to be able to not assign any default route via DHCP. The stock firmware doesn't seem to be able to do this.Dd-wrt appears to be...
View ArticleCan I access Eero router settings through Linux
so we have a Linksys router and a eero router connected to our internet. My stepdad won’t give me the password to the eero and keeps blocking my phone and computer from accessing the router just to be...
View Articlerouter command to change bandwidth limit for a MAC address
I use DD-WRT to limit WAN bandwidth to one MAC address using DD-WRT's web interface.The key entry in the web interface (in "NAT/QoS" tab's "QOS" tab) is "MAC priority",which I normally set to 10000...
View ArticleAlternative to LibreCMC/OpenWRT that is easier to upgrade?
I use LibreCMC (based on OpenWRT) for my wifi router, and I really hate it. Every time I upgrade, everything breaks, and I have to manually log in and fix everything, by hand, and remember what I did...
View ArticleCan't ping hostnames and IPv6 after router restart
This happened after a router restart.(no idea if this is relevant but my Windows PC also reverted the DNS settings to an old local server I tested)I noticed the issue when I ssh'ed to my homelab...
View Articlesetup wireless router using systemd-networkd *.network files
I would like to configure an embedded device to behave as a wireless router, and I would like to achieve it preferably using networkd configuration files.I have two *.network files, a wired WAN...
View ArticleRouter configuration. Sharing the same network over two interfaces
I have a router, R, and two hosts, A and B. They are all running Ubuntu 22.04.I have both physical access and necessary permissions to all machines involved in the setup and I would like to ssh from B...
View ArticleHow to set up two NICs in same machine different subnets and route from one...
I have a computer (RPi CM4) with two NICs.I want one (eth0)set up on network 1 and the other (eth1) on network 2. I need to be able to see computer on net2 from net1.I have eth0 set for 192.168.1.x/23,...
View ArticleForward IP-address to server behind Turris Omnia
A few years ago I setup my Turris Omnia to forward an external IP-address to an internal server.Unfortunately I have forgotten how (or maybe Turris Omnia changed the interface).
View ArticlePlaying Music through Sonos Speaker connected to ETH Raspberry Pi
I have a Raspberry Pi Wifi-to-Ethernet bridge, and have a Sonos Symfonisk speaker plugged into the Ethernet output. In it's current configuration I can't play music through the speaker, is there a...
View ArticleCannot get IP forwarding work in docker container
I am wanting to set up a playground to test some nftables firewall rules before I put them on a real router. Docker containers seem to be good lightweight instrument for this. A prerequisite of this...
View ArticleNetwork Connectivity Issue: Unable to Ping two VMs on eth1
I've configured two VMs and assigned them to the eth0 and to the eth1 interface.However, I'm encountering connectivity issues as I'm unable to ping between two VMs using eth1. I've verified the network...
View ArticleHow to pause WLAN interface in linux?
I am working on a project with a Wi-Fi router (TP-Link) installed with dd-wrt firmware. A latop is directly connected over eth port with the router (as an adminsitrator who controls the router over...
View ArticleFind out what MAC addresses are connected to each physical LAN port of router
I'm managing a router running Linux 3.10.87-rt80-Cavium-OcteonOn the router's GUI, there's a "Switch ports" page where I can see all ethernet ports (4 LAN - 2 WAN) and their corresponding link...
View ArticleInstall Debian on Mikrotik RB 2011 routerboard
Is there any way to install Debian sid on Mikrotik RB 2011?Seems to Debian MIPS port not support this type of cpu (Atheros 600MHz 74K MIPS big-endian), I already install OpenWRT on this device, need to...
View ArticleHow to force update NTP date/time on a router?
The log of an Asus router with Padavan firmware (might be similar to OpenWrt) showed:Dec 4 16:06:20 NTP Client: Synchronizing time to 0.nl.pool.ntp.org.Oct 24 18:18:18 NTP Client: System time changed,...
View ArticleIsolate subnet with DD-WRT router
I have my ISP gateway (which is a regular wifi router) which is 192.168.178.1. This is connected to a DD-WRT router (using it's WAN port).I've had this setup for a while now and pretty much the default...
View ArticleUbuntu router using nftables blocking traffic
I'm trying to set up a simple router in Ubuntu. There are two network interfaces: eth0 - a wired network interface connected to the internet, and wlan0 - configured as an AP with IP address...
View Articleunable to connect to internet via router
I'm on Dell Latitude 3420, Devuan Daedalus GNU/Linux (based on Debian Bookworm, without systemd),I connect to internet via mobile hotspot (using Android Phone's mobile data) at home and through a...
View ArticleHow to setup a dedicated NordVPN router and gateway on linux?
The problem is this:The only officially supported router configuration for nordvpn is to use a static config file and openvpn.That doesn't work for me.The question:Using linux, how does one setup a...
View ArticleRouter SSID disappearing from list of scanned networks on all clients...
I have a H68K Linkstar router with an Openwrt snapshot installed. My clients attempt to manually connect when they so choose, but the router SSID does not appear in the list of available networks. Upon...
View Article
More Pages to Explore .....